You must be 18 years to order
from this web site
Please Call TOLL FREE 1 877 435 9866 to
Place an order! We accept all major Credit Cards
Click on Icon Above to Place an Order
Wing Area: 1100 sq. in.
Ready-to-fly weight: 9 - 10 pounds
Whether you are a pattern flyer, 3D flyer, or a sport
flyer the Icepoint is the right choice for you. This design was created,
based upon the success of the 3D Quest, to cater to the flyers wanting a
cost effective alternative to the more expensive artistic freestyle type
designs. The construction consists of the traditional “built-up” balsa
and ply techniques.
Building time is reduced as the wing is pre-mounted,
joined and glassed. The stabilizer is an adjustable two- piece design.
This plane hovers and 3D’s very well, but you have the best of both
worlds in that is flies FAI with the best of them. The best trademark of
this plane is that it is very light and has superior knife edge
performance with very little (if any) knife edge coupling required.
Construction: Laser-cut balsa & plywood construction.
Wings: Once piece wing (pre-joined, glassed, and pre-mounted) and built-
up two – piece stabilizer.
Double beveled control surfaces.
Covering: Factory applied Oracover covering with vinyl graphics.
Belly Pan / Cowl: Precision matched pre-painted fiberglass.
Wheel Pants: Pre-painted fiberglass.
Canopy: Pre-formed and tinted.
Landing Gear: Molded pre-painted composite. (Fixed to the fuselage)
Dual Aileron Servos / Pull-Pull Rudder
Hinge Slots: Pre-slotted for “easy-type” CA hinges
Building Time: Ready to fly in 10 – 12 hours.
Pre-built & covered wings, tail assemblies, and fuselage. All necessary
hardware including pushrods, landing gear, wheels, servo trays, wing
joiners, and a photo illustrated instruction manual.